6-21
1
2
3
4
5
6
7
8
9
PERIODIC MAINTENANCE AND MINOR REPAIR
tery, a special (constant-voltage)
battery charger is required. Us-
ing a conventional battery
charger will damage the battery.
If you do not have access to a
sealed-type (MF) battery charger,
have a Yamaha dealer charge
your battery.
EAUT1240
Replacing the fuse
1
ZAUM00**
1. Fuse
The fuse holder is located beside the
battery. Remove panel A to access the
fuse. (See page 6-6.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
Specified fuse:
7.5 A
Fuse, replacing<IXE>
ECA10640
cC
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
3. Turn the key to “ON” and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows again,
have a Yamaha dealer check the
electrical system.
3D1-F8199-12_ch6.pmd 2007/05/24, 20:0321
To Next Page
Loading...
Need help?
General