9-12
9
To check the engine oil level
1. Park the vehicle on a level surface.
2. Remove the rear cup holder panel by re-
moving the quick fastener screws.
3. Start the engine and warm it up to a nor-
mal operating temperature (the engine oil
temperature should reach 60 °C [140 °F]),
then let the engine idle for a minimum of
10 seconds before turning the engine off.
If the engine is cold, take the vehicle for a
short drive or let it idle for approximately 10
minutes before checking the engine oil level.
4. Remove the engine oil tank filler cap and
wipe the dipstick with a clean rag.
5. Insert the dipstick back into the oil tank
(without screwing it in), and then remove
it again to check the oil level.
The engine oil level should be between the tip
of the dipstick and the maximum level mark.
1. Rear cup holder panel
2. Quick fastener screw
UBAR11E0.book Page 12 Monday, July 27, 2020 4:42 PM
To Next Page
Loading...
