5-35
5
When adjusting the damping force settings,
turn the adjuster in direction (a) until it stops,
and then count the clicks in direction (b).
EWB00411
These shock absorber assemblies contain
highly pressurized nitrogen gas. Read and
understand the following information be-
fore handling the shock absorber assem-
blies.
Do not tamper with or attempt to open
the cylinder assemblies.
Do not subject the shock absorber as-
semblies to an open flame or other high
heat source. This may cause the unit to
explode due to excessive gas pressure.
Do not deform or damage the cylinders
in any way. Cylinder damage will result in
poor damping performance.
Do not dispose of a damaged or worn
out shock absorber assembly yourself.
Take the shock absorber assembly to a
Yamaha dealer for any service.
EBU37411
Rear shock absorbers
EWB00411
These shock absorber assemblies contain
highly pressurized nitrogen gas. Read and
understand the following information be-
fore handling the shock absorber assem-
blies.
Do not tamper with or attempt to open
the cylinder assemblies.
Slow compression damping force settings:
Minimum (soft):
18 click(s) in direction (b)
Standard:
13 click(s) in direction (b)
Maximum (hard):
1 click(s) in direction (b)
UBAR11E0.book Page 35 Monday, July 27, 2020 4:42 PM
To Next Page
Loading...
