Need help?Do you have a question about the Yamax Digi-Walker SW-700 and is the answer not in the manual?
General| Category | Pedometer |
|---|---|
| Step Count | Yes |
| Step Count Range | Up to 99, 999 steps |
| Distance Measurement | Yes |
| Calorie Count | Yes |
| Memory | 7-day memory |
| Power Source | Battery |
| Battery Type | CR2032 |
| Display | LCD |
| Display Type | Digital |
| Stride Length Setting | Yes |
| Model | Yamax Digi-Walker SW-700 |
| Type | Digital Pedometer |
| Distance Range | Up to 999.99 km or miles |
| Battery Life | Approximately 1 year |
| Units | km or miles |
Press 'C' button to move cursor to 'DIS (km)' or 'DIS (mile)', then press 'D' button.
Stride length increases by 1 cm or 0.25 ft, from 30 cm/1.00 ft to 180 cm/6.00 ft.
After setting stride length, cursor automatically moves to 'DIS (km)' or 'DIS (mile)'.
Press 'C' button to move cursor to 'CALORIE (kcal)', then press 'D' to input body weight.
Body weight increases by 1 kg or 1 lbs, from 30 kg/70 lbs to 120 kg/300 lbs.
After setting body weight, cursor automatically moves to 'CALORIE (kcal)'.
Display dimming indicates the battery needs replacement. Use LR-44 type.
Use a coin to open the cover, remove the old battery, and insert a new one (+ side facing you).
Press all buttons for 5 seconds after replacement; then re-input data like stride length.
Hold case vertically, shake up/down with display facing you; meter is intended for flat ground.
Avoid irregular steps, dragging feet, sandals, vibrating motion, jumping, or steep slopes.
To Next Page