Need help?Do you have a question about the Y&Y Vertical Clip Up and is the answer not in the manual?
General| Brand | Y&Y Vertical |
|---|---|
| Model | Clip Up |
| Category | 3D Glasses |
| Language | English |
Details the parts of the belay glasses: prisms, frame, clip-on mechanism, silicone covers, rotating shaft, and stopper.
Describes the glasses case: storage, clip support, Velcro closure, anti-shock, and carabiner attachment.
Lists included accessories: microfiber cloth, anti-slip ear hooks, and additional silicone covers for legs.
Clip glasses in the middle of the frame with silicon legs on lenses. Prisms should be in front of eyes or higher.
Describes the 'On' position (prisms in front of eyes) and 'Off' position (prisms on forehead) for normal view.
Frame allows viewing the climber and peripheral vision for surroundings and belay device control.
Prisms may shorten perceived distance, affecting balance. Use reference points to adapt quickly.
Place glasses in 'Off' position, then flip down when climber reaches second anchor (approx. 3m). Keep hand on rope.
Initial eye strain may occur but disappears. Glasses do not replace natural view; check climber without glasses if in doubt.
Avoid using glasses in rockfall areas. Do not look directly at the sun.
Keep belay glasses in a dry environment away from heat sources for longevity and efficiency.
Use microfiber cloth for cleaning. Avoid touching prisms with fingers and store in the provided case.
To Next Page
