electromagnetic switch. When the starting switch is connected, the electromagnetic
switch makes tooth of the gear and flying wheel gear ring, connect the circuit for starting
the motor and then drive the flying wheel.
After the diesel is connected, turn off the starting motor immediately. The iron
core drives the gear to its original position under the control of spring. Continuation for
use of the starting motor may not exceed 15 seconds. The interval for two starts shall be
2-3 minutes. If the diesel can not be started for continual three times, please check and
remove the faults. The duration for powering the electric heating plug may not exceed 30
minutes.
To Next Page
Loading...
