PERIODIC MAINTENANCE
96 6LY3 Operation Manual
PERIODIC MAINTENANCE
PROCEDURES
Perform the following maintenance after
the initial 50 hours of operation.
• Replace Engine Oil and Engine Oil
Filter
• Check Electronic Control System
Operation
• Adjust Propeller Shaft Alignment
Replace Engine Oil and Engine
Oil Filter
The engine oil on a new engine becomes
contaminated from the initial break-in of
internal parts. It is very important that the
initial oil change is performed as
scheduled.
It is easiest and most effective to drain the
engine oil after operation while the engine
is still warm.
After Initial 50 Hours of
Operation
A WARNING
BURN HAZARD!
• If you must drain the engine oil
while it is still hot, stay clear of
the hot engine oil to avoid
being burned.
• ALWAYS wear eye protection.
• Failure to comply could result
in death or serious injury.
0000011en
CAUTION
• Only use the engine oil
specified. Other engine oils
may affect warranty coverage,
cause internal engine
components to seize, or
shorten engine life.
• Prevent dirt and debris from
contaminating engine oil.
Carefully clean the oil
cap / dipstick and the
surrounding area before you
remove the cap.
• NEVER mix different types of
engine oil. This may adversely
affect the lubricating
properties of the engine oil.
• NEVER overfill. Overfilling may
result in white exhaust smoke,
engine overspeed or internal
damage.
0000005en
To Next Page
Loading...
