19
TROUBLESHOOTING
Problem Possible cause Possible solution
Shredder not running No Power Check power outlet and plug
Locking lever (4) is in down
position
Push the locking lever to ON position
Forward/reverse button is in
middle position
Press the forward/reverse button to
forward position
Shredder is overloaded Reset the shredder by press the reset
button
Shredder is faulty Repair by an authorised service centre
Vibrating Screws are loose Tighten the screws
Cutting blade is worn Replace the cutting blade by an autho-
rised service centre
Not cutting Cutting blade is worn Replace the cutting blade by an autho-
rised service centre
Gap between the cutting
blade and shaving plate is
too big
Adjust the adjusting screw
Shredding material is
not cut cleanly
Gap between the cutting
blade and shaving plate is
too big
Adjust the adjusting screw (5)
Chip size is too big or
too small
The gap between the cutting
blade and shaving plate
either too big or too small
Adjust the adjusting screw (5)
To Next Page
Loading...
