Yardbeast YB2090 User Manual

Carefully clean
the cutting chamber
each use.
WARNING
The rotor blade
is sharp.
leather gloves
to protect your
hands when cleaning
the
chamber.
NOTE: Blasting pressurized water
recommended.
Taking care of your engine
NOTE: Review the sections of
maintenance
and operation of the engine
detailed instructions.
1. Check the oil level.
2. Clean the
engine regularly with
cloth or brush. Keep
clean
intake system
to allow proper
circulation.
Remove all grass
and combustible debris
from muffler
area.
SERVICING
Rotor Blade
WARNING
The rotor blade is sharp.
Wear
leather gloves
to protect your
hands when the
cleaning
chamber.
Blade re-sharpening
1. Stop the
engine, disconnect the spark
plug and
check that the rotor of the chi
has stopped completely.
2.
Remove the discharge deflector
3.
Remove the discharge size screen
4. Remo
ve the blade port by unscrewing
the four 5mm hex socket scr
ews.
5.
Blade must be sharped at a 30deg. angle
the cutting chamber
after
is sharp.
Wear
to protect your
the
cutting
is not
maintenance
manual for
engine regularly with
a
clean
the air
to allow proper
air
Remove all grass
, dirt
from muffler
Wear
to protect your
cleaning
cutting
engine, disconnect the spark
check that the rotor of the chi
pper
Remove the discharge deflector
(STEP 1).
Remove the discharge size screen
(STEP 2)
ve the blade port by unscrewing
ews.
(STEP 3)
Blade must be sharped at a 30deg. angle
and must not overheat to loose its heat
treatment properties.
6. Retighten.
Tools used: 9/16" Hex Wrench , 5mm hex key.
NOTE: To remove the blade
’s
recommended
to place a piece of wood in
between the rotor and the outside edge to
prevent it from rotating when
torque on the nuts from the back
Anvil sharpening or
adjustment
1. Loosen the bolts
from under
seating. Use a 9/
16 "
5mm hex key.
2.
Between the blade
you must leave a
approximately
3/16
clearance
is important to
best chipping
performance
3. Make sure that
the
tightened.
Anvil
17
and must not overheat to loose its heat
Tools used: 9/16" Hex Wrench , 5mm hex key.
’s
bolts, it is
to place a piece of wood in
between the rotor and the outside edge to
prevent it from rotating when
applying
torque on the nuts from the back
.
adjustment
from under
the anvil
16 "
Hex Wrench and
Between the blade
and the anvil,
you must leave a
space of
3/16
” (`5mm). This
is important to
ensure
performance
the
bolts are re
Anvil

Yardbeast YB2090 Specifications

General

Brand	Yardbeast
Model	YB2090
Category	Other
Language	English