Assemble the feed chute onto the the
chipper opening -
below-
by screwing the 9 bolts required.
Start by screwing the first two top bolts with
a nut so the hopper doesn't come off while
puttin in p
lace the remanining bolts.
a.9 Hex Bolts 5/16" x 1"
b.9 Hex Nuts 5/16"
c.9 Flat washer 5/16"
Setting up your Wood Chipper
Operation
Fuel & Oil
Read and follow
manual for more information on
Once you have finished
wood chipper, you must
engine for the first start. Locate
in the top of the engine
should fill the tank
approximately 7 liters of clean
Assemble the feed chute onto the the
by screwing the 9 bolts required.
Start by screwing the first two top bolts with
a nut so the hopper doesn't come off while
lace the remanining bolts.
Setting up your Wood Chipper
for
engine
this matter.
your
fuel cap
it. You
with
.
WARNING
Use extreme
handling fuel.
explosive.
machine indoors
running or hot.
pipes and
When putting oil into the engine, it is better
to use a funnel to prevent spills on the
machine. The engine uses approximately
liters
of oil. Engine oil is a fluid with significant
viscosity, it takes a bit of time to settle
important to always wait some time before
measuring the oil level with the dipstick
Please use the following oil type according
to your outdoor operation temperature
range.
Change the oil at the first 20 hours of
operation, then
hours of operation.
10
caution when
Fuel is highly
are
refuel the
the engine is
, cigars,
n.
When putting oil into the engine, it is better
to use a funnel to prevent spills on the
machine. The engine uses approximately
1.2
of oil. Engine oil is a fluid with significant
viscosity, it takes a bit of time to settle
, it is
important to always wait some time before
measuring the oil level with the dipstick
Please use the following oil type according
to your outdoor operation temperature
Change the oil at the first 20 hours of
To Next Page
Loading...
General