Please stay close to the Yardian device
when doing "Wi-Fi onboarding".
Check Yardian’s LED status. Yardian
should be in Wi-Fi AP mode to proceed
(LED blinking green and blue).
If Yardian is not blinking green
and blue, please press and hold
the Wi-Fi reset button for around
5 seconds and release when you
see the LED blinking green and
blue.
If your Yardian is in Wi-Fi AP mode
for more than 15 minutes, you will
be asked to reboot Yardian (Press
Wi-Fi reset button until LED turns
red).
LED in purple!
SN
MAC
YID :
AA00754F
: <MAC Number>
: <Serial Number>
Press
24
Step 5.
To Next Page
Loading...
Need help?
General