TIRE PRESSURE
Check the pressure of tires periodically to make sure
they are properly inated. Recommended pressure is
30psi for all the tires.
Separation of tire and rim parts is possible when they
are serviced incorrectly.
Do not attempt to mount a tire without the proper
equipment and experience to perform the job.
Do not inate the tires above the recommended pressure.
Do not weld or heat a wheel and tire assembly.
Welding can structurally weaken or deform the
wheel. Heating can cause an increase in the air
pressure resulting in burst.
Do not stand in front or over the tire assembly while
inating.
ENGINE MAINTENANCE
Refer to the Engine Manual included in your unit
for the information on engine maintenance. Your
engine manual provides detailed information and a
maintenance schedule for performing the tasks.
Figure 10a
Figure 10b
LUBRICATION
The gearbox is pre-lubricated and sealed at the
factory. No need to lubricate until 50 hours use.
After rst 50 hours use, change all the transmission
oil. Capacity is 1.5L.
For future use, just check the oil level every 50 hours
of working. If remove the drain plug, no oil ow out,
then add the oil.
Use portable tool lithium #0 grease such as Lubriplate
6300AA , Lubriplate GR-132, or Multifak, e.g. EP-O.
Transmission oil must be replace when engine is
stopped and warm by unscrewing ller cap and drain
plug. When oil is completely drained, replace ller cap
and ll up with fresh oil. (See Figure 10a)
19
YD4103PM02 - 1706
|
Maintenance