YARDMAX YD8103 User Manual

M6×20
M8×20 (×4)
Belt Cover for Gearbox Pulley
Belt Cover
Drive Belt
Gearbox Pulley
M8 × 25
M8 × 25
5/16 × 30
1
Jam Nut
Lock Nut
2 3
Jam Nut
Adjustment Nut
Adjustment Nut
Jam Nut
Figure 5a
1
Jam Nut
Jam Nut
Lock Nut
Lock Nut
2
Adjustment Nut
3
Jam Nut
Adjustment Nut
Lock Nut
If the above adjustment does not create enough cable
tension, follow the steps below:
1. Loosen the jam nut by turning it counter clockwise
with 12mm wrench. (see Figure 5b, Illustration 1)
2. Tighten or loosen the cable by turning the cable
adjustment nut clockwise or counter clockwise with
10mm wrench until you have reached your required
tightness. (see Figure 5b, Illustration 2)
3. Once tightness is set, return the jam nut against the
handle to hold the cable in place. (see Figure 5b,
Illustration 3)
Figure 5b
REPLACING DRIVE BELT
Remove the belt covers as show. (See Figure 6a)
Loosen the two bolts M8×25 and one bolt 5/16×30
that x the two belt blockers, no need to remove them.
Pull out the belt. (See Figure 6b)
Figure 6b
Figure 6a
10 mm
13 mm
17 mm
19 mm
12 mm
9 mm
30 mm
8 mm
10 mm
13 mm
17 mm
19 mm
12 mm
7 mm
30 mm
8 mm
10 mm
13 mm
17 mm
19 mm
12 mm
7 mm
30 mm
8 mm
X 2
You may need to loosen the belt guide bracket and
slide back before removing belt.
16
Power Trackbarrow
»
Operator’s Manual
YD8103PM03 - 1802
Maintenance
|
17 mm
18 mm
30 mm
13 mm
11 mm
X 2
17 mm
18 mm
30 mm
13 mm
11 mm
X 2
10 mm
13 mm
17 mm
19 mm
12 mm
9 mm
30 mm
8 mm
X 2

YARDMAX YD8103 Specifications

General

Brand	YARDMAX
Model	YD8103
Category	Construction Equipment
Language	English