CHARGING PROCEDURE
Note: The battery can be charged in or out of the mower.
The charger that is supplied with this mower is a specially designed 2-stage charger.
Step 1: The red light will light up during the recharge cycle.
Step 2: The green light will light up when the battery is fully charged.
1. Remove the jack cover.
2. Plug the charger connector into the jack on the battery.
3. Insert the 120 V plug from the charger into the electrical outlet.
4. The red light on the charger should come on, which indicates that the charger is working and the
battery is being charged.
The red light will go out and the green light will come on when the battery is completely charged (it
takes approximately 15 hours to charge a fully discharged battery).
WARNING: Never operate the mower without a proper trail shield, discharge cover, grass
catcher, switch, or other safety protective device in place and in working order. Do not
operate the mower with a damaged safety device. Doing so can result in injury.
To Next Page
Loading...
Need help?
General
