Yardworks 060-1981-4 - Removing; Emptying the Grass Collection Bag

model no. 060-1981-4 | contact us: 1.866.523.5218 model no. 060-1981-4 | contact us: 1.866.523.5218
17
AssemblyAssembly
WARNING: Before you remove the grass collection bag, switch off
the mower, remove the battery pack, and ensure the blades have
come to a standstill.
WARNING: Always check the rear discharge guard closes tightly
before using. Never lift the rear discharge guard when the lawn
mower is in operation.
4. REMOVING / EMPTYING THE GRASS COLLECTION BAG
- Removing (See Fig. D)
Raise the rear discharge guard and hold it up. Lift the grass collection bag by the handle
upwards a little, and then remove the grass collection bag from the rear discharge chute.
- Emptying
As soon as you see mown grass debris on the lawn, the grass collection bag needs to be
emptied.
1) Empty the grass clippings from the grass collection bag into the appropriate bin. Check
with your local municipality for disposal of grass clippings. Ret grass collection bag per
previous instructions.
2) If any grass clippings are caught in the rear discharge chute, clean it using a broom or
similar extension.
3) Do not remove grass debris from under the deck, or on/around the blades by hand or with
your feet. Instead use suitable tools such as a brush or broom.
4) To ensure that the grass clippings can be blown into the grass collection bag, the rear
discharge chute, and the inside of the mower deck must be cleared of any blockage.
NOTE:
• Always empty the grass collection bag before it has reached its maximum capacity.
• Do not leave grass clippings in the grass collection bag for extended periods of time.
D
1
2