model no. 060-2371-0 | contact us: 1.866.523.5218
13
STARTING AND STOPPING
BEFORE STARTING YOUR HEDGE TRIMMER
Remove blade sheath.
TO START YOUR HEDGE TRIMMER (See FIG. C)
Your trimmer is equipped with two switch levers (3
& 4). Both switch levers need to be pressed for the
hedge trimmer to start. Depress and hold safety
handle switch (3) and press on/off switch (4).
TO STOP YOUR HEDGE TRIMMER
Move hedge trimmer away from cutting area before
stopping.
To stop, release either the safety handle switch (3) or on/off switch (4), the Trimmer will stop
almost immediately.
IMPORTANT TIPS FOR TRIMMING HEDGES
• Assume secure posture and hold Trimmer with both hands. If using a step ladder make
sure it is securely located and if working high tie the ladder to the thicker inner branches
of the hedge.
• Ensure no people or animals are in the work area.
TOP CUTTING (See FIG. D)
Use a wide sweeping motion. A slight downward tilt of the cutting blades in the direction of
motion gives the best cutting results.
SIDE CUTTING(See FIG. E)
When trimming the sides of the hedge, begin at the bottom and cut upwards, tapering the
hedge.
inward at the top. This shape will expose more of the hedge, resulting in a more uniformed
growth.
Operation
model no. 060-2352-6 | contact us: 1.866.523.5218
!
WARNING: If any parts are missing, damaged or broken, do not operate
your hedge trimmer until all damaged parts have been replaced or
repaired. Failure to do so could result in serious personal injury.
C
D
E
To Next Page
Loading...
Need help?
General