Digital Velocity Follower
Date: 07/01/04, Rev: 04-07 Page 5 of 13 TM.G5SW.045
Gear Tooth 1
P1-01= 1
P1-01 Gear Tooth 1
A A A A
Setting Range: 0 to 10000
Factory Default: 1
Modbus Address: 0580H
This is the “Numerator” portion of the pulse ratio. (See Figure 2)
Gear Tooth 2
P1-02= 1
P1-03 Gear Tooth 1
A A A A
Setting Range: 0 to 10000
Factory Default: 1
Modbus Address: 0581H
This is the “Denominator” portion of the pulse ratio. (See Figure 2)
Ratio Setting
P1-03= 0.00
P1-03 Ratio Setting
A A A A
Setting Range: -99.99 to +99.99
Factory Default: 0.00
Modbus Address: 0582H
Sets the amount of frequency reference increase or decrease (draw) as a percentage of the incoming reference.
(See Figure 2)
To Next Page
Loading...