YASKAWA JVOP-182 - LED Status Indicators

4 LED Operator Option Components
YASKAWA ELECTRIC TOBP C730600 35B YASKAWA AC Drive Option LED Operator Installation Manual 13
5
Down Arrow
Key
Scrolls down to display the next item, selects parameter numbers
and increments setting values.
6STOP Key
Stops drive operation.
Note: The STOP key can be enabled or disabled when operating
from the external terminal or network communications by setting
parameter o2-02.
7ENTER Key
• Enters parameter values and settings.
• Selects a menu item to move between displays.
8
LO/RE
Selection
Key
Switches the drive between operator (LOCAL) control and
control circuit terminals (REMOTE).
Note: The LOCAL/REMOTE key is only effective at a stop in
drive mode. As a safety precaution, it is possible to disable the
LO/RE Selection Key by setting parameter o2-01 (LOCAL/
REMOTE Key Function Selection) to “0” (disabled).
<1>
9 RUN Light
Illuminated while the drive is operating the motor.
Refer to LED Operator LED Status Indicators on page 14 for
detail.
10 LO/RE Light
Illuminated while the drive is under LED Operator control when
(LOCAL) is selected to run the drive.
11
ALM LED
Light
Refer to LED Screen Display on page 15
12
REV LED
Light
13
DRV LED
Light
14
FOUT LED
Light
<1> o2-01(LOCAL/REMOTE Key Function Selection) is not compatible with J1000. LO/RE Selection Key is always
effective.
No. Key Name Function
S
T
T
O
O
TO
TO
P
RE
LO