Why does my YATO Grinder tool start and then slow down?
If your YATO Grinder starts but then slows down, the issue might be that the compressor isn't providing enough air. To fix this, try connecting the grinder to a more efficient compressor.
How to fix slow rotations or start issues in my YATO Grinder?
If your YATO Grinder has slow rotations or won't start, it could be due to the blades sticking to the rotor or to excessive oil. Try these steps: 1. Let a small amount of WD-40 through the air inlet. 2. Run the tool for a few seconds. 3. Run the tool for about 30 seconds. 4. Lubricate the tool with a small amount of oil. If the issue is from the excess of oil, clean the drive.
What to do if my YATO YT-09676 has insufficient power?
If your YATO Grinder isn't providing enough power, ensure your hoses have the correct internal diameter as specified in point 3. Also, verify that the pressure is set to the maximum. Make sure the tool is properly cleaned and lubricated. If problems persist, the tool should be submitted for repair.
To Next Page
General
