Why won't my YATO YT-73125 Measuring Instruments turn on?
Your YATO Measuring Instruments might not turn on because the batteries are incorrectly installed, the batteries are worn out, or the switch button lacks electric contact. To resolve this, ensure the batteries are installed with the correct polarity, install new batteries, or press the switch harder. If the problem persists, have the laser distance meter serviced.
What to do if my YATO YT-73125 clicks during measurements?
The clicking sound you hear during measurements with your YATO Measuring Instruments is a normal phenomenon. It is the sound of the optical path switching.
Instructions for correctly replacing device batteries.
Procedures for turning the laser distance meter on and off.
Performing a single distance measurement.
Measuring the surface area of a rectangle.
Measuring the volume of a cuboid.
Indirect distance measurement using two right-angled triangles.
Performing measurements in motion.
Performing addition/subtraction of measurement values.
Explains error codes, their sources, and solutions.
General| Category | Measuring Instruments |
|---|---|
| Measuring Range (Distance Meter) | 0.05 - 40 m |
| Laser Type | 635 nm, <1 mW |
| Units of Measurement | m, in, ft |
| Memory | 20 measurements |
| Power Supply (Distance Meter) | 2 x AAA batteries |
| Resolution (Caliper) | 0.01 mm |
| Display | LCD |
| IP Rating | IP54 |
| Model | YATO YT-73125 |
| Accuracy (Distance Meter) | ±2 mm |
| Laser Class | Class II |
| Functions | Distance, Area, Volume, Pythagoras |
| Accuracy (Caliper) | ±0.03 mm |
To Next Page
