. --
LUBRICATION
\_-'
Front Wheel Bearing Pivot Bolt
All-purpose grease into All-purpose grease into
grease fitting. grease fitting.
, / .
".
t
!
'
~~
,cO
,cO ,
i: ~,
"
1 Gear Lever , Thin coat of all-purpose
grease on contact areas
of moving parts.
., e into
v
"-- on
II
Cutting Section
Thin coat of all-purpose
grease on contact areas
of moving parts.
valve
Brake/Clutch Shaft
~ Thin coat of all-purpose
grease on contact areas
of moving parts. to
To avoid gasoline spilling or entering the
Pulley Idler Arm crankcas~ close the. s.hut-off valve when
Thin coat of all-purpose transportln.g .or .servlclng your mc:>wer, ?r
" grease on contact areas whe.never It IS likely that the engine ml~ht
of moving parts. be tilted. Turn the shu~-off valve clockwls.e to
\ close. counter clockwise to open. If possible,
, after closing the valve. run the motor until
\- it cuts off in order to burn all the fuel from
the carburetor.
i
I
I 11
~1'
°"