Yazoo YHR Series - Page 13

OPERATING PROCEDURES
NOTE - Looking at tractor from cutting section, lift arm ~'\
.on right side of cutting section will go against wheel -)!J
side of tractor mounting bracket. Left lift arm will go
against inside of tractor mounting bracket.
4 Secure each rod end (3) with each lift arm (5 and 6) to tractor mounting brack-
ets (10 and 11) with bolt (12), washer (13), and nut (14).
GP5 ('jj) ~
'< '1
.
~fl.JiJ)
8 ~~~d~ )
9 'c
I
i
!
I ~)) I
:
!
NOTE - Do not force halves of PTO shaft together.
Forcing them together indicates that they are not
properly aligned and will cause severe damage
to unit. When splines are aligned correctly, halves
will slide together easily.
5 Align marks on pro shaft (15) and join halves of pro shaft (15) together.
6 Secure cutting section half of PTO shaft (15) to mower with roll pin (16) and
setscrew (17).
YAZOO YHR':SERIES MOWERS 12 (}) ~
OWNER'S MANUAL
r= -~~ ---