i
i
!
t BILL OF MATERIAL:
;jj 1. Housing, Yoke Assy. 5. Bolt PIN 209-314
. YR 36, 42 & 48 YR-36 PIN 806-200 Washer, Lock PIN 2301-006
STABILIZER BAR YR-42 PIN 806-201 6. Shaft, Stabilizer PIN 1904-185
Q. YR-48 PIN 806-20,2 7, Bolt PIN 209-032
/ 2, Pin, Pulley PIN 1604-060 Washer, Lock PIN 2301-003
Pin, Cotter PIN 1604-003 Nut PIN 1401-010
i 3 Bracket PIN 214-211
I ; 4: Pin, Rivet PIN 1604-061
j . I Pin, Cotter PIN 1604-002
1 I DIRECTIONS:
I
~ -' 1. Remove regular cable pulley shaft and install Yoke of Part
I f - No.1 over the pulley housing. Secure with enclosed Shaft
No.2.
/' / 2. Bolt Part No.3 to the cutting section in place of Y AlOO
/ Bracket No. 214-121.
i G) / 3. Put Shaft No.6 in housing No.1 and attach lower end to
/ \ Bracket No.3 using Pin No.4.
/
~ f 4. Secure cable and spring to lower end of Shaft No.6.
'0' 5. Adjust double Nuts to allow desired amount of travel
/ ~ between shaft and housing.
C9 / ~\ ::
It 0
/ ~\ ~ I -', ,
// X~.~/ ~ '0
/ ~.._~~
~: -if ~
/ "1
!~~~~~::i~" (9 ~~~~~~ - - - - J,L - ~ "
.9 0
SHIPPING WEIGHT - 6 Ibs. Q- - - -
- -
BILL OF MATERIA.L: 4. Pin, Rivet PIN 1604-061
1. Housing W/Yoke Assy. Pin Cotter PIN 1604-002
YR 60 76 ,
, YR-60 PIN 806-203 5. Bolt PIN 209-314
STABILIZER BAR YR-76 PIN 806-204 Washer, Lock PIN 2301-006
2. Pin, Pulley PIN 1604-060 Bolt, 1/4 x PIN 209-032
Pin, Cotter PIN 1604-003 Washer, Lock PIN 2301-003
3. Shaft, Stabilizer PIN 1904-185 Nut 1/4 x PIN 1401-010
DIRECTIONS:
1. Remove re!]ular Pulley Shaft and install Yoke of Part No.1 over the
Pulley Housing, Secure with Shaft No.2.
~ 2. Put Shaft No.4 in Housing No.1. and attach lower end to Bracket No.
j' 214-101 using Pin No.5. .
0 3. Secure cable to lower end of Part No.4. Replace spring on No. 214-101
, Bracket.
4. Adjust double nut to allow desired amount of travel between shaft and
housing,
/
,. SHIPPING WEIGHT -6 Ibs.
; ;.('" ~
, ,. /
'
I" 0 " i-
I I CD
I @ //..1-
r /
- - /
- /
':I ,
r '~;~~;;;~~~;~~;;~~~;;~~)
f
To Next Page
Loading...