YDSTRONG EMS MAX - Managing Training Sessions

23
13.Enter the training setting
interface, select the part that
needs to be exercised, or
select all, set the discharge
duration and interval
duration. Click on to start
training. The ALL key below
is to select all, and the "+"
and "-" keys are for adjusting
the intensity.
Note: You need to press the "+" key
to increase the intensity within the
discharge time after starting. During the
interval or pause, you can only press the
"-" key to decrease the intensity but not
increase the intensity.
14.Choose the position that
needs training, the red is the
selected state, the gray is the
unselected state.
※Note: No matter whether it is selected
or not, as long as the number on the
electrode sheet is not zero, there is
output.