www.yealink.com
The flow diagrams of registration is shown below:
Repeater
switch on
Set base station
in registration
mode
Repeater
DECT LED
is green
Ready for use
Base station
switch on
Handset enable
repeater mode
Placement
To achieve optimum performance for the repeater, it is important to find a
good location.
Here are a few tips for placing repeaters:
Choose a raised position for both the base station and repeater wherever
possible.
When positioning the repeater, avoid obstacles that can interfere with
radio transmission such as thick wall and metal structures that may be in
the coverage area between the base station and repeater.
Avoid interference from other electrical appliances such as micro-wave
ovens, Hi-Fi equipment, computers etc.
Keep a minimum of 10 meters between multiple repeaters to avoid
coverage area overlapping.
1. Hold the handset and stand near the base.
2. Make a call, and carry the handset away from the base.
3. Make a note where you start to hear noise on the line, which indicates
the signal is getting weaker.
The optimum location for the repeater is as far from the base as possible
while still maintaining a good signal, or just inside the location where the
noise became noticeable.
DECT Repeater RT20 User Guide
Register the RT20 to base station
within the “good” signal range.
Make a call, then
walk away from the
base to determine
the signal range.
Strong signal
range
Good signal
range
Week signal
range
To Previous Page
Loading...
Need help?
General
