11
4. Lift and close the release lever (9) until it fully engages the hinge.
5. If the device is equipped with fold-away handles, set them up by pulling
them apart. If not, the handles are already set up in the correct position.
6. The process is complete.
Folding
1. Place the device in front of you in a horizontal position.
2. If the device is equipped with folding handles, fold them away to the sides
if needed.
3. Unlock the device by lowering the lever (9).
4. Push the folding lever (14).
5. Lower the scooter frame by 90 degrees.
6. The process is complete.
4.3. CHARGING AND BATTERY INDICATOR
Charge the battery before rst use. To do so, charge the device using the
charger supplied.
Important: Only charge the device with the original charger supplied with
the device by the manufacturer. In case of doubt, loss or malfunction, avoid
charging the device with another charger and get a new one from your retailer.
All information is available via support_uk@yeep.me
Next, check the battery charge level before use, using the battery level indi-
cator (20).
Notice: We recommend you fully recharge the battery after each use and at
least once a month.
WARNING: The device must be unfolded and on its stand for charging to avoid
damaging the charging plug.
1. Remove the charging port cover and ensure there is no water or any other
liquid inside the charging connector, and that it is free of any objects that
could cause a short circuit or prevent the plug from being properly and safely
plugged in. Then, connect one end of the charging cable to the charging port
(13) BEFORE connecting the other end to a power source. BEFORE connecting
the plug to the mains, ensure that the charger is rst connected to the device
correctly by referring to the codes on the device.
To Next Page
Loading...
Need help?
General