This manual will help you to use the many
features of your new digital torque wrench.
Before operating the torque wrench, please read
this manual completely, and keep it nearby for
future reference.
FEATURES
● Interchangeable head
● Digital torque value readout
● +/- 2% accuracy
● CW and CCW operation
● Peak hold and track mode selectable
● Buzzer and LED indicator for the 9 pre-set
target torques
● Water contact indicator
● Engineering units (ft-lb, in-lb, N-m, kg-cm)
selectable
● Stores up to 50 data les for recall and joint
torque auditing
● Auto Sleep after about ve minutes idle
● (2) AAA Batteries included
MAINTENANCE AND STORAGE
CAUTION:
1. Over-torque (110% of
Max. torque range)
could cause breakage
or loss of accuracy.
2. Do not shake violently
or drop wrench.
3. Do not use the wrench
as a hammer.
4. Do not leave the wrench in any place exposed to
excessive heat, humidity, or direct sunlight.
5. Do not use the wrench in water (not waterproof).
6. If the wrench gets wet, wipe it with a dry towel
as soon as possible. The salt in seawater can be
especially damaging.
7. Do not use organic solvents, such as alcohol or
paint thinner when cleaning the wrench.
8. Keep the wrench away from magnets.
9. Do not expose the wrench to dust or sand as this
could cause serious damage.
10. Do not apply excessive force to the LCD panel.
11. Apply torque slowly and grasp the center of the
handle. Do not apply load to the end of the
handle.
BATTERY MAINTENANCE
1. When the wrench is not used for an extended
period of time, remove the battery.
2. Keep a spare battery on hand when going on a
long trip or to cold areas.
3. Do not mix battery types or combine used
batteries with new ones.
4. Sweat, oil and water can prevent a battery’s
terminal from making electrical contact.
To avoid this, wipe both terminals before
loading a battery.
5. Dispose of batteries in a designated disposal area.
Do not throw batteries into a fire.
ATTENTION:
To maintain accuracy, a one-year
periodic recalibration is recommended.
Please contact your local dealer for
calibration details.
2
To Next Page
Loading...
