SMARTBENCH V1.3 – STANDARD, PRECISION AND PRECISIONPRO
Home SmartBench 25
Manual Square 26
Auto Square 26
Open a file 27
Set X/Y datum 28
Set Z datum (start point for the job) 30
Run job 32
Setting the laser datum 33
Removing and Replacing a Spindle 35
You will need to: 35
Step 1: Disconnect cables 36
Step 2: Loosen spindle cage collar 36
Step 3: Replace spindle 37
Step 4: Connect cables 37
Troubleshooting 38
SmartBench will not power on 38
Console will not boot 38
SmartBench will not home correctly 38
Software will not update 38
Console will not connect to the Wi-Fi 39
USB will not read 39
SmartBench is in an alarm state 39
Spindle does not power on 39
Extraction does not power on 39
Support 39
Unit 12 Old Mill Road | Portishead | Bristol | BS20 7BX | UK
2
To Next Page
Loading...