YOKOGAWA SC450G - Preface; Table of Contents>

IM 12D08N05-01E
i
<PREFACE>
PREFACE
Thank you for purchasing the SC450G Conductivity Converter.
Please read the following respective documents before installing and using the SC450G
Conductivity Converter.
The related documents are as follows.
 GeneralSpecications: GS12D08N05-01E
 User’sManual:  IM12D08N05-01E(thismanual)
* the “E” in the document number is the language code.
AnexclusiveUser’sManualmightbeattachedtotheproductswhosesufxcodesoroption
codescontainthecode“Z”(madetocustomers’specifications).Pleasereaditalongwith
this manual.
WARNING
Electrostatic discharge
The SC450G converter contains devices that can be damaged by electrostatic discharge.
When servicing this equipment, please observe proper procedures to prevent such
damage.
Replacement components should be shipped in conductive packaging. Repair work should
be done at grounded workstations using grounded soldering irons and wrist straps to avoid
electrostatic discharge.
WARNING
Installation and wiring
The SC450G converter should only be used with equipment that meets the relevant IEC,
American or Canadian standards. Yokogawa accepts no responsibility for the misuse of
this unit.
CAUTION
The Instrument is packed carefully with shock absorbing materials, nevertheless, the
instrument may be damaged or broken if subjected to strong shock, such as if the
instrument is dropped. Handle with care.
No.IM12D08N05-01E 5thEdition:Aug.2017(YK)
AllRightsReserved.Copyright©2007,YokogawaElectricCorporation