Need help?Do you have a question about the Yokomo MR-4TC Drift and is the answer not in the manual?
General| Scale | 1/10 |
|---|---|
| Shock Type | Oil-filled dampers |
| Type | Drift Car |
| Chassis | MR-4TC |
| Wheelbase | 257mm |
| Width | Varies by body |
| Height | Varies by body |
| Drivetrain | Shaft-driven |
| Suspension | Independent Double Wishbone |
| Differential | Ball Differential |
| Body Material | Polycarbonate |
| Motor | Not included |
| ESC | Not included |
| Servo | Not included |
| Battery | Not included (7.2V NiMH or 2S LiPo compatible) |
| Radio System | Not included |
Assembles the front and rear ball differentials for optimal performance.
Installs the motor and pinion gear, adjusting gear mesh.
Installs the servo saver and mounts the servo to the chassis.
Assembles the shock absorbers, including pistons and springs.
Completes the assembly of all four shock absorbers.
Mounts the assembled shocks to the front and rear shock towers.
Installs the receiver and speed controller onto the chassis.
Installs assembled stick-pack batteries onto the chassis.
Installs side-by-side battery packs onto the chassis.
To Next Page
