4
REMOVE CHUTE FROM BASE
1. Rotate chute clockwise.
2. Remove chute assembly from base.
DISASSEMBLE CHUTE
3. Unscrew bottom cap
from blade cover
(counter-clockwise).
Dishwasher-safe Components
Wash all five (5) components of chute assembly
with soap and warm water or in the top rack of
a dishwasher. Wipe base with damp cloth.
DO NOT submerge base, plug or cord in any
liquid or allow liquid to enter motor housing or
electrical components.
CAUTION: DO NOT attempt to
disassemble, clean or service
your Yonanas maker while power
switch is on and/or electrical cord is
plugged into power source!
WARNING:
Blades are
very sharp!
Do not touch blades.
DISASSEMBLY
CLEANING
4. Carefully remove blade cone.
CAUTION:
Blades are sharp.
5. Remove gasket by lifting.
To Next Page
Loading...