e Page 23 f
Panel Installation
10
Panel Installation
CAUTION
DO NOT place the panel facedown on the floor, against
a wall, or on uneven surfaces.
Step 1: Remove the front grille.
1. Push both of the tabs towards the middle
simultaneously to unlock the hook on the grille.
2. Hold the grille at a 45° angle, lift it up slightly and
detach it from the main body.
Fig. 10.1
Fig. 10.2
Fig. 10.3
Fig. 10.4
Step 2: Install the panel
Align the indicate "△" on the decoration panel to the
indicate "△" on the unit .
Attach the decoration panel to the unit with the
supplied screws as shown in figure below.
1 Intake grille
2 Grille hook
1 Decoration panel
2 Screws (M5)(supplied with the panel)
After installing the decoration panel, ensure that there is
no space between the unit body and decoration panel.
Otherwise air may leak through the gap and cause
dewdrop. (See figure below)
To Next Page
Loading...
