Need help?Do you have a question about the YORKVILLE MP8DX and is the answer not in the manual?
General| Channels | 8 |
|---|---|
| USB Interface | No |
| Line Inputs | 8 |
| EQ | 3-band on each channel |
| Effects | Built-in digital effects processor |
| Phantom Power | Yes |
Critical warning against opening the unit to prevent electrical hazards.
Provides essential safety instructions to mitigate risks of fire, electric shock, and injury.
Covers reading manual, packaging, power, hazards, cord care, and qualified servicing.
Highlights the MP8DX as a powerful, lightweight, and versatile mixer/amplifier.
Details XLR mic inputs (phantom power) and 1/4" BAL LINE IN jacks.
Explains gain adjustment range and the function of the CLIP LED indicator.
Describes the independent LOW, MID, and HIGH EQ controls for each channel.
Explains the MON control for sending channel signal to the monitor bus.
Details the EFX control for sending channel signal to the effects bus.
Adjusts overall main mix level and indicates high signal levels in the main bus.
Adjusts overall monitor mix level and indicates high signal levels in the monitor bus.
Regulates effects signal to the main mix and record out.
Regulates effects signal to the monitor bus.
Provides line-level main mix output and direct input to the 400W amplifier.
Offers monitor mix output and auxiliary input to the 200W amplifier.
Provides pre-EQ main mix signals for recording to tape decks.
Connects footswitch for effects or acts as an effects send/return jack.
Details controls for selecting and varying 16 banks of reverb, delay, and other effects.
Indicates signal strength to the digital processor, warning of potential distortion.
Refers to the last page of the manual for a detailed effects table.
Explains graphic EQ gain controls and their effect on system frequency response.
Details functions for feedback reduction, bass response adjustment, and artistic sound shaping.
Describes 1/4" speaker jacks, load ratings, and heatsink cooling.
Locates the power switch and fuse, with instructions for fuse replacement.
Guides connecting AC power and setting master controls before powering on.
Details connecting XLR mics, 1/4" line inputs, and RCA stereo inputs.
Explains speaker connections to AMP A/B and routing monitor signals.
Covers speaker placement and step-by-step control adjustments for sound checks.
Provides procedures to identify and reduce monitor feedback using EQ and master controls.
Lists key mixer specifications including inputs, EQ, effects, and dimensions.
Details amplifier ratings, harmonic distortion, and signal-to-noise ratio.
Specifies voltage and frequency requirements for North American and European units.
Details mixer input, output, EQ, and phantom power specifications.
Provides frequency response, gain, sensitivity, THD, and power output.
Details 7 categories of single effects: Rooms, Halls, Chambers, Delays, Gated Reverb.
Details 8 categories of combo effects blending multiple effects.
Details the 'Special Effects' category including pitch shift and flanger.
To Next Page
