Installation Introduction
1. Baby unit installation and connection
(1) Connect the baby unit with the parent unit:
Connecting
Camera
Register
O
please press
the pair key
on the baby
O O O
unit
O O
2
O
(2) Mount the baby unit on the wall
Use the template below to mark the wall at the correct location to drill holes for the wall
mounting screws (not provided). The two grooves at the bottom of the baby unit and the
screws that have been fixed on the wall are used for hanging and fixing.
o
EN
NOTE:
o
O
34600
6mm
headscrew
6mm
headscrew
Do not place the baby unit within the reach of infants! If the picture or sound is
unclear, try moving the device to a different location and make sure they are not close
to other electronic devices.
Yoton
4
bm.support@yoton.co
To Next Page
Loading...
Need help?
General
