2. Charging and Power On/Off
(1) Baby unit power supply
Connect the Baby unit end with the power supply, it must be connected to power at all
times when in use
Parent unit power supply
When the parent unit is fully charged, it can be unplugged and used.
(2) Power On/Off
Press and hold the power button at least 3 seconds to turn on the parent unit, then the
two units will be connected automatically.
Installation Introduction
1. LCD display icon introduction
10.01
O Signal strength indicator
@ Temperature of the baby's room
Yoton
30t
EN
22 : 36
O Date and time
@ Battery indicator
5
(5 Alarm activated
bm.support@yoton.co
To Next Page
Loading...