7
•
The location display start to flash, Now use the “+" or " -“ to set the correct city
following the city list (see LOCATION list at the end of this manual) . Press “MODE” to
confirm your setting and to end the setting procedure.
INFORMATION:
After approx. 20 seconds without a button being pressed, the clock switches
atomically from Setting mode to Normal clock mode.
SETTING THE WAKE-UP ALARMS
The weather station possesses two daily alarms. One alarm is for Monday to Friday
(A1), a second alarm for the weekend, Saturday and Sunday (A2).
Proceed as follows to set the alarms:
•
Press “MODE” one time to select the A1 (Alarm 1) mode, and hold down the “MODE”
button for three seconds until the A1 hour is flashing.
•
Now use the “+" or " -“ buttons to set the alarm hour.
•
Press the “MODE” button to set the A1 minute. Now use the “+" or " -“ buttons to set
the alarm minutes.
•
Press the “MODE” to confirm
•
To set Alarm 2 (A2), proceed as described above.
•
Press “MODE” to enter A1 mode, press “-“ button to turn on the alarm icon.
•
Press “MODE” to enter A2 mode, press “-“ button to turn on the alarm icom.
•
If you want cancel the alarm, enter again A1 or A2 and press “-“ button one time to
cancel the alarm.
INFORMATION:
•
After approx. 20 seconds without a button being pressed, the clock switches atomically
from Setting mode to Normal clock mode
•
The alarm will sound for two minutes if you do not deactivate it by pressing any button.
In this case, the alarm will be repeated automatically after 24 hours.
•
Crescendo alarm: 2 minutes sound - increases in sound in 4 steps.
•
If you have set a time zone, the alarms will be activated based on this zone time
AUTOMATIC SNOOZE FUNCTION
•
To activate the automatic snooze function: While the alarm is sounding, press the
“SNOOZE/LIGHT” button to activate the snooze function. When the snooze function is
activated, the Alarm icon will blink.
•
The snooze cycle is five minutes.
To Next Page
Loading...