Yu Fong YF-20 User Manual

YF-20 MANUAL
This model YF-20 Sound Level Meter is suited to checking noise levels in almost
any environment including factories, offices and homes.
The meter is designed to provide the preferred “A” weighted response. This
response is universally accepted for environmental noise measurements and is
similar to that of the human ear.
Features
1. One-handed simple, easy to operate
2. In-built reference signal.
3. In-built battery test.
4. Quickly, accurately measures sound level.
5. Compressed scales minimize range switching.
Battery Installation
1. The meter requires one 9 volt battery (Type 216, 006P 622 or similar).
2. Slide the battery cover down from the rear of the meter.
3. Connect the battery to the matching snap connector and fit the battery to the
battery compartment so that the bottom of the battery is below the “CAL ADJ
“ marking and the battery wires are concealed behind the battery.
4. Replace the battery compartment cover.
Battery Test
1. Rotate the control knob to the “BATT” position.
2. If the meter needle is within the range of the blue ‘B.OK’ scale then the battery is
usable.
*Note: Do not leave the control knob in the “ BATT” position as this could quickly
flatten the battery.
Calibration Check
1. An internal reference signal is available for checking the meter’s operation.
2. Rotate the control knob to the “CAL” position.
3. The meter needle should indicate 70Db, any other reading may indicate that the
meter has been damaged.
4. Though not normally necessary, the reading can be re-calibrated by adjusting the
“CAL ADJ” control located.
5. In the battery compartment, using a non-conductive screwdriver.
*Note: Before attempting re-calibration, ensure that the battery is in good condition.
Proper calibration requires suitable test equipment.

Yu Fong YF-20 Specifications

General

Model	YF-20
Type	Digital Multimeter
Power Supply	9V Battery
Operating Temperature	0°C to 40°C
Display	LCD

Summary

YF-20 Sound Level Meter Manual

Product Features

Highlights the key characteristics of the YF-20 Sound Level Meter for ease of use and accuracy.

Battery Installation Guide

Step-by-step instructions for correctly installing a 9-volt battery into the sound level meter.

Battery Test Procedure

Instructions on how to perform a battery test using the 'BATT' position and interpret the results.

Calibration Check

Guidance on checking meter operation using the internal reference signal and calibration adjustment.

Operation and Specifications

Meter Operation

Steps for operating the sound level meter, including initial checks and measurement techniques.

Technical Specifications

Details on the meter's range, current consumption, size, and weight.

Cautions for Use

Important warnings regarding handling, impact, and battery leakage to ensure meter longevity.

Noise Level Examples

A list of common sound sources with their corresponding decibel (dBA) levels for reference.

Product Warranty Information

Warranty Coverage

Details the 12-month warranty period and requirements for service.

Warranty Service and Rights

Instructions for returning the product for warranty service and information on legal rights.