Yukon SENTINEL 26015T User Manual (English)

Other manuals for Yukon SENTINEL 26015T

Questions and Answers:

M
Michael BarrettAug 16, 2025
Why my Yukon SENTINEL 26015T Riflescope does not turn on?
- R
  Rose SchultzAug 16, 2025
  If your Yukon Riflescope doesn't turn on, it might be due to several reasons. First, ensure that the batteries are installed with the correct polarity. If they are, the total battery charge might be too low (less than 2.0 V), so try installing fresh batteries. Also, check the battery compartment for oxidized contact points, which can occur due to leaky batteries or exposure to reactive solutions. If you notice oxidation, clean the battery compartment, paying special attention to the contact points.
A
Amy LawrenceAug 19, 2025
What to do if there is displacement of the reticle while shooting with Yukon SENTINEL 26015T?
- K
  Kaitlyn TravisSep 12, 2025
  If you experience displacement of the reticle while shooting with your Yukon Riflescope, it could be because the scope isn't securely mounted. Ensure that the scope is firmly attached to the mount. Also, verify that you're using the same type and caliber bullets as when the scope was initially sighted in. Keep in mind that if the scope was sighted in during a different season (e.g., summer vs. winter), a slight displacement of the aiming point is possible.
H
Hunter HoffmanAug 22, 2025
How to fix blurred target image with Yukon Riflescope?
- R
  Ryan Scott MDAug 22, 2025
  If you have a crisp reticle image but the target at least 30m away appears blurred when using your Yukon Riflescope, consider these potential causes: * The eyepiece might not be adjusted correctly. Ensure you adjust it following the instructions in the “OPERATING THE SENTINEL” section. * Dust and moisture might be covering the outside optical surfaces. Clean the lens surfaces with a soft cotton tissue or cloth. * Condensation might have collected on the inside of the objective and eyepiece lenses, or on the optical surfaces of the electronic-optical converter. If the scope fogged due to a rapid change in temperature, let the unit dry by leaving it in a warm environment for 4 hours.
J
Joyce KellyAug 25, 2025
How to adjust Yukon SENTINEL 26015T Riflescope if it does not focus?
- S
  Stephen CampbellAug 26, 2025
  If your Yukon Riflescope does not focus, it may be due to incorrect settings. Adjust the scope according to the instructions in the “OPERATING THE SENTINEL” section. Also, check the condition of the eyepiece and objective lens. If necessary, clean the lenses of any dirt, dust, condensation, or frost. To prevent fogging in cold weather, apply a special anti-fog solution.
D
Dr. Jeffrey AlexanderAug 27, 2025
What to do if Yukon SENTINEL 26015T Riflescope doesn't turn off?
- D
  Dana PhillipsAug 27, 2025
  If your Yukon Riflescope or the IR illuminator doesn't turn off using the “ON/OFF” switch on the scope, it's possible that the scope was activated by remote control. Try turning off the scope and the IR by using the remote control.
A
Autumn JonesAug 30, 2025
Why is red reticle blurred on Yukon Riflescope?
- G
  Glen WolfAug 30, 2025
  If the red reticle in your Yukon Riflescope is blurred and cannot be focused with the eyepiece, the eyepiece might not be adjusted correctly. Adjust the eyepiece according to the instructions in the “OPERATING THE SENTINEL” section.
J
Jacob BrownSep 1, 2025
Why is the image of the target blurred with my Yukon Riflescope?
- K
  Kara MelendezSep 2, 2025
  If you're seeing a blurred image of the target at 30m or more with a crisp reticle on your Yukon Riflescope, consider these possibilities: 1. The eyepiece may not be adjusted correctly. 2. Dust and moisture might be covering the outside optical surfaces; clean the lens surfaces with a soft cotton tissue or cloth. 3. Condensation might have collected on the inside of the objective and eyepiece lenses. If the scope fogged due to a rapid temperature change, let the unit dry in a warm environment for about 4 hours.
B
Brooke BlankenshipSep 4, 2025
How to fix a Yukon Riflescope that does not focus?
- F
  Fred WilliamsSep 5, 2025
  If your Yukon Riflescope isn't focusing, it could be due to incorrect settings. Adjust the scope following the instructions in the “OPERATING THE SENTINEL” section. Also, check the eyepiece and objective lens condition. If necessary, clean the lenses of any dirt, dust, condensation, or frost. To prevent fogging in cold weather, consider applying a special anti-fog solution.
T
Timothy ZavalaSep 7, 2025
What to do if my Yukon Riflescope doesn't turn off?
- S
  Scott TaylorSep 7, 2025
  If your Yukon Riflescope or the IR illuminator doesn't turn off using the 'ON/OFF' switch, it's possible that the scope was activated by remote control. Try turning off the scope and the IR by using the remote control.
A
Amy WilliamsSep 10, 2025
Why is the red reticle blurred on my Yukon Riflescope?
- M
  Monique BaileySep 10, 2025
  If the red reticle in your Yukon Riflescope appears blurred and cannot be focused with the eyepiece, the eyepiece might not be adjusted correctly. Adjust the eyepiece according to the instructions in the “OPERATING THE SENTINEL” section.

Yukon SENTINEL 26015T Specifications

General

Brand	Yukon
Model	SENTINEL 26015T
Category	Riflescope
Language	English

Yukon SENTINEL 26015T Manual

Table of Contents

Other manuals for Yukon SENTINEL 26015T

Questions and Answers:

Yukon SENTINEL 26015T Specifications