Modes can be changed during dying to ensure all areas can be accessed.
Use purple handle to rotate orb in either position.
V
e
r
t
i
c
a
l
m
i
x
i
n
g
p
o
s
i
t
i
o
n
instruction manual
• Design Studio Mixing
Ball with Handle
• X6 Dye Bottles
• X12 Dye Powders
(Approx. 1g each)
• Technique Booklet
• X10 Elastic Bands
• Clear Gloves
• Bottle Stickers
• Instructions
CONTENTS:
Screw pink water caps to each
end tighten using purple
handle.
Twist base of handle onto
base using location lugs as
shown.
Push centre of handle
down onto base as shown.
Push nozzle into self-sealing
valves and gently squeeze in dye.
Ensure you do not squeeze the
bottle until the nozzle in fully
inside the orb.
* For best results do not over
squeeze the bottles and over
soak the fabric. We recommened
1/2 a bottle of each colour.
H
o
r
i
z
o
n
t
a
l
m
i
x
i
n
g
p
o
s
i
t
i
o
n
Wash through over sink until
water runs clear.
Unscrew the yellow caps
and carefully remove item
from Orb and remove
elastic bands.
Leave item to dry. Cold hand wash only. We
recommend washing dyed fabrics at least
3 times before washing with your other
laundry, as the dye colour may bleed out a
little during your first few washes.
Hold the blue handle and give it
a little mix!
Once fully tie dyed remove
handle from base. If there is
any excess dye in the orb this
can now be removed into a sink.
Make sure to use purple handle
as key to unlock the caps.
Reseal the orb & leave in Orb
for 6-8 hours for best results.
Alternatively take out
carefully and place in clear
plastic bag to use Orb again.
Remove top and bottom cap over
sink. Use purple handle as key
for untightening.
Swirl & Style™ Tie Dye Studio
is a trademark of YULU®. © 2020 YULU International Ltd.
All Rights Reserved. Trademarks and Patents pending.
Manufactured by: YULU International Ltd. | Room 2104, 21/F, K. Wah Centre, 191 Java Road, North Point, Hong Kong.
www.yulutoys.com | support@yulutoys.com
Product style and colors may vary from package. Please retain package for future reference and retain instructions as it
contains important safety information. Please remove all packaging material before giving to children. An adult should
periodically check this toy to ensure no damage or hazards exist, if so, remove from use. Children should be supervised
during play.
This product should be used by children above six years only. Please ensure you cover and protect surfaces and clothing.
Adult supervision required
CONFORMS TO ASTM D-4236.
US TG YL060060 IM 01
14
b
15
14
a
13
16 17 18 19
20 21 22
To Next Page
Need help?
General
