Press and hold the
POWER
and
MODE
buttons at the
same
time to access the settings. in exchange for configuration. Press
MODE
to advance (1) or press
POWER
to decrease. Desired configuration will be set after about 3 seconds.
Note: Keep the default values of the parameter settings, please do not change them at will. (p9 is an electronic brake, can be
adjusted, or is not electronic
Press
MODE
to go to the next setting from
PO
Wheel diameter in inches. Default = 10
Voltage cut. Default = 38
Magnetic poles in the hub motor. Default = 10
Speed sensor function. Default = 0
0 #
Km
/
h, 1 # Mh. (speedometer in kilometer or mile)
0 = Start without kick 1 = Start with kick
P6 0 = No cruise 1 = Cruise
P7 0 = Start of power 1 = Normal start
P8 Power setting, from 0 to 100, 100 means total power
P9 Electronic value of the braking force. Default = 2
P10 Function to be determined.
2.3
Fault screen
Whenthe
electric
vehicle
fails,
theinstrument showsdefectivecomponents, suchasengine
failure (
), controller failure
(
), controller failure (
),
and so on.
2.4
Function Screen
Some
meter functions
will
show symbols, respectively, headlights on
( )
USB
charging
( ).
2.5
Wiring harness definition
Red: VCC
Orange: electric lock
Black: earth
Green: Hall signal
Blue: signal transmission
Yellow: signal reception
10
To Next Page
Loading...
Need help?
General
