To Next PageTo Next Page
Need help?Do you have a question about the Yunlink CPE870 and is the answer not in the manual?
General| Brand | Yunlink |
|---|---|
| Model | CPE870 |
| Category | Wireless Access Point |
| Language | English |
Explains the purpose of WAN/LAN ports and the required power supply for the CPE.
Provides two methods to reset the CPE to factory default settings.
Illustrates the physical connection between the CPE, PoE adapter, and PC for setup.
Details how to set the computer's local IP address for device communication.
Guides users on entering the IP address and default credentials to access the device interface.
Instructions for configuring the AP in Gateway mode, including SSID and channel settings.
Steps for setting up Repeater and Station modes, scanning, and bridging APs.
How to configure the AP mode to transmit wireless signals for wired networks.
Guide for configuring the device in WISP mode to connect to an ISP access point.
Introduces access to advanced settings like System Status and 2.4GHz Wireless.
Details on configuring the LAN interface, including access type selection.
Covers setting time zone, viewing logs, and managing user credentials.
Step-by-step instructions for browsing and upgrading the device firmware.
Configuring computer network settings to obtain IP and DNS automatically for internet access.
Provides solutions for common failure phenomena and connectivity problems.
