YZAKI 5.7M3/H AVEC TIMER

Questions and Answers

E
Emily SkinnerAug 7, 2025
Why is sand flowing to the pool from my YZAKI 5.7M3/H AVEC TIMER?
- N
  Nathan JacksonAug 7, 2025
  If sand is flowing into your pool when using the YZAKI Water Dispenser, several factors could be at play. First, the sand might be too fine; it's recommended to use 0.45 mm to 0.85 mm #20 silica sand. Another potential cause is switching the control valve from backwash to filter without stopping the sand filter—always halt the filter when adjusting the valve. Also, check that the sand level is within the “MAX” and “MIN” markings on the collector hub. Finally, a broken skimmer can cause this issue, so consider replacing it.
J
John PetersonAug 12, 2025
What to do if there is no water flow in my YZAKI 5.7M3/H AVEC TIMER Water Dispenser?
- L
  Linda DavidsonAug 13, 2025
  If your YZAKI Water Dispenser has no water flow, there are several possible reasons. Ensure that you've removed the stopper plugs and inserted the debris screens. Check if air needs to be released from the system. Verify that the control valve is set to the filter function, not closed. Also, the strainer might be blocked and need cleaning. If none of these steps work, the sand filter might be broken and require professional service.
A
Amanda WrightAug 19, 2025
Why does my YZAKI 5.7M3/H AVEC TIMER have excessive filter pressure?
- K
  kaylanguyenAug 19, 2025
  Excessive filter pressure in your YZAKI Water Dispenser can stem from a few issues. The filter may be dirty, requiring a backwash. The sand bed might be calcified, necessitating inspection and possible replacement. Insufficient backwashing could also be the culprit; backwash until the water runs clear. Lastly, the pressure gauge itself could be faulty and need replacement.
N
Nicole HallAug 25, 2025
Why is the control valve leaking from the port D in my YZAKI Water Dispenser?
- M
  Melissa GonzalezAug 26, 2025
  If the control valve on your YZAKI Water Dispenser is leaking from port D, it could be due to the valve being set between two functions; ensure it's set to a single function. Alternatively, the gasket may be broken and need replacement.
S
Susan FordAug 31, 2025
How to fix leaking connectors on my YZAKI 5.7M3/H AVEC TIMER Water Dispenser?
- N
  nicholasrobinsonAug 31, 2025
  If the connectors on your YZAKI Water Dispenser are leaking, check the following: Ensure the connector washers are correctly positioned. If a washer is broken, replace it. Also, make sure all hoses are tightened properly.