ZAERO DESIGN EVO-1 - User Manual

EVO-1 REAR SPOILER
FOR VW GOLF 7 & 7.5
Installation Manual
WWW.ZAERO-DESIGN.COM
We wish you a lot of fun with your new spoiler!
Tuning is not just a passion, it’s a lifestyle!
Enjoy it!
APPLYING THE REAR SPOILER TO THE CAR
Line up the spoiler in position. Make sure that the corners of the spoiler have a
nice even gap to the front and especially to the sides. Make sure you can still
reach the detached protective lm of the tape.
3
Now press the corners of the spoiler lightly against the car. Once again, make
sure that the gaps are even. You can now carefully pull out the protective lm
of the tape from under the rear spoiler. Press the spoiler rmly against the
surface where the tape is placed.
You can now remove the protective lm of the rear spoiler.
Note: The tape needs up to 24 hours to develop its full adhesive strength.
Installation is not recommended, especially in colder temperatures.

Summary

Test Fitting and Surface Preparation

Test Fitting the Rear Spoiler

Perform a test fitting of the spoiler on the car's roof edge to check contact points.

Cleaning and Tape Application

Clean the car's roof edge and spoiler areas, ensuring they are grease-free before applying tape.

Applying the Rear Spoiler to the Car

Positioning and Initial Attachment

Line up the spoiler, ensuring even gaps, then press corners lightly and pull protective film.

Final Spoiler Attachment and Notes

Firmly press the spoiler, remove remaining film, and note tape needs 24 hours for full adhesion.

ZAERO DESIGN EVO-1 Specifications

General

Brand	ZAERO DESIGN
Model	EVO-1
Category	Automobile Accessories
Language	English