Wear gloves to prevent accidents when installing the product.
Severe damage may occur when mounting the system, so do not apply excessive force.
Connecting the cable incorrectly may cause a fire due to a short circuit. Make sure to refer to the manual when
connecting the cable.
Be careful not to block the ventilation hole of the product when using the system.
Avoid locations with direct sunlight, water, moisture, oil, and excessive dust. Store and use the product in a well-
ventilated location.
Do not wipe the surface of the product using chemicals. (organic solvents such as alcohol or acetone)
Do not insert your hand or other object into the product during operation, as this may injure your hand or
damage the object.
Store and use the product out of children’s reach.
Our company assumes no responsibility for any problem that occurs due to the use of the product for purposes
other than its designated purposes and/or the carelessness of the consumer.
The exterior design and specifications of the product are subject to change without prior notice to consumers for
quality improvement.
Specifications
Model T8
Case Form Factor ATX Mid-Tower
Dimensions 394.5 x 200 x 423(H)mm
Weight 2.6kg
Case Materials Plastic, Steel
Motherboard Support ATX / mATX / Mini-ITX
Maximum VGA Length 295mm
Maximum CPU Cooler Height 160mm
Maximum PSU Length 140mm
PCI Expansion Slots 7
Drive Bays 1 x 5.25″, 2 x 3.5″, 4 x 2.5″
Front Fan Support
Front 2 x 120mm / 2 x 140mm
Rear 1 x 120mm
Side 1 x 120mm
Fan(s) Included Rear 1 x 120mm
Radiator Support
Front 1 x 120mm 1 x 120mm
Rear 120mm
I/O Ports
Power Button, RGB LED Button, 1 x
Mic, 1 x Headphone, 2 x USB2.0, 1 x
USB3.0
To Next Page
Loading...
