Zamel Ledix WDN-03 User Manual

www.ledix.pl
230 V AC
Cet Lighting Sp. z o.o.
43-200 Pszczyna, ul. Zielona 27
tel: +48 32 449 15 00, fax: +48 32 449 15 02
e-mail: ledix@ledix.pl, www.ledix.pl
The WDN-03 touch switch is used to switch on or switch o the light by means of a touch. It is equipped
in one 230 V AC output. WDN-03 switch is used to control the traditional lighting source (halogens,
incandescent lighting, uorescent) or LED diodes. Maximum power supply that can be connected to the
voltage output of the switch should not exceed 300 W (for traditional light bulbs).
In case of low-voltage light sources (12 V AC halogens, LED diodes) it is necessary to connect a trans
-
former / a power supply to the WDN-03 touch switch with an appropriate power input.
WDN-03 has an automatic calibration process during the change of sensor’s connection place or the
touch surface. This allows the switch sensor to be connected to larger conductive surfaces. In addition,
the applied construction solutions allow for a safe use of WDN-03 switch even by persons with an im
-
planted articial pacemaker.
WDN-01 touch switch is designed to be mounted on surfaces such as wood and wood-based imitation
materials thicker than 2 mm, and they are also designed for plasterboard mounting.
The touch switch fulls the requirements of harmonized standards in the scope of safety use or
electromagnetic compatibility.
Features:
• low power consumption during stand-by mode,
• output voltage 230 V AC,
• the relay contact with a maximum load of 5 A 250 V AC,
• automatic calibration process referring to the change of a sensor’s connection place or the touch sur
-
face.
• safe use even by persons with an implanted artificial pacemaker,
• surface mounting with a possibility to screw (e.g. to a furniture board).
WDN-03 GB Ver. 01
Touch switch
TYPE: WDN-03
Touch switch
WDN-03
230 V AC / 0,9 W; IP20
weight: 60 g
Declaration of Conformity is at www.ledix.pl
Touch switch
WDN-03
The symbol means selective collecting
of electrical and electronic equipment.
It is forbidden to put the used
equipment together with other waste.
Surface
mounting
Indoor mounting
only
A detailed mounting description is inside the packaging
Switch
sensor
cable length:
1,5 m

Zamel Ledix WDN-03 Specifications

General

Brand	Zamel
Model	Ledix WDN-03
Category	Switch
Language	English

Summary

Touch switch WDN-03 Introduction

Product Description and Features

Overview of the WDN-03 touch switch's functionality, power output, and safe use for pacemakers.

Product Details and Specifications

Detailed Description

Explains the WDN-03 device's function, connection, power, and suitability for various lighting sources.

Appearance and Terminals

Visual representation and labeling of sensor, output, and power supply terminals for the WDN-03.

Technical Data Summary

Key specifications including voltage, power consumption, channels, sensor length, and dimensions.

Wiring Diagrams

Illustrates exemplary LEDIX series lighting fittings connection for 12V AC and 14V DC power supplies.

Mounting Instructions

Provides step-by-step guidance for safe installation and connection of the WDN-03 switch.

Important Cautions

Highlights essential safety precautions for connecting and using the WDN-03 switch.