Zamel ROP-01 - Page 8

RADIO TRANSMITTERS PROGRAMMING
MONOSTABLE mode:
Press transmitter’s push-button for a longer time.
Press PROG push-button of ROP-01 device for a longer time until LED red
diode switches on (constant signal). Next release PROG push-button.
Release transmitter’s push-button. LED red diode switches on (rst signal
pulsates, next the signal is constant).
Press the same transmitter’s push-button and release it. LED red diode
switches on (the signal pulsates) and next it switches off - THE TRANSMITTER
IS ADDED.
BISTABLE mode:
Press PROG push-button of ROP-01 device for a longer time until LED red
diode switches on (constant signal). Next release PROG push-button.
Press the transmitter’s push-button for a longer time. LED red diode switches
on (rst signal pulsates, next the signal is constant).
Release transmitter’s push-button. LED red diode switches on (the signal
pulsates), next the LED red diode switches off - it means the TRANSMITTER IS
ADDED.
SWITCHON/SWITCHOFF mode (two push-buttons):
Press PROG push-button of ROP-01 device for a longer time until LED red
diode switches on (constant signal). Next release PROG push-button.
Press and release transmitter’s pushbutton. LED red diode switches on (rst
signal pulsates, next the signal is constant).
Press and release the same transmitter’s push-button. LED red diode switches
on (the signal pulsates) and next it switches off - THE TRANSMITTER IS
ADDED.
TIME mode (one push-button)
Press PROG push-button of ROP-01 device for a longer time till LED red diode
switches on (constant signal). Next release PROG push-button.
Press and release transmitter’s pushbutton. LED red diode switches on (the
signal pulsates, next the signal is constant).
Press and release the same transmitter’s push-button. LED red diode switches
on (the signal pulsates) and next it switches off - THE TRANSMITTER IS
ADDED.
An exemplary programming procedure. The procedure for the all of radio EXTA
FREE transmitters is analogous. CAUTION: Every transmitter can cooperate
withROP-01inadifferentmode,dependingonhowtheywereaddedtothe
device. One transmitter can beadded during one programming cycle. Full
memoryissignalledwithpulsatingLEDreddiode.