ZAMST A1 - Attaching Stirrup and Control Straps; Securing the Logo Strap and Final Check

4. Fasten the stirrup strap.
Stirrup strap
With your feet on the oor, pull the stirrup strap up to an extent
that it does not sag, fasten the strap to the product, and apply
rm pressure to the hook-and-loop fastener.
* Do not pull the strap up with excessive force as doing so
may cause skin and/or circulatory problems.
5. Pull the dual inversion control strap to fasten it to the product.
The effect of the dual inversion control strap varies depending on which direction you pull it.
① When the strap is pulled diagonally
upward:
① When the strap is pulled diagonally
upward: Inversion is restricted
because the non-stretchable strap is
contracted.
Dual inversion
control strap
Stretchable
strap
Non-stretchable
strap
Stretchable
strap
Dual inversion
control strap
② When the strap is pulled laterally
(inward):
② When the strap is pulled laterally
(inward): Side-to-side instability is
restricted because the stretchable
strap is strongly elongated.
6. Fasten the strap bearing with the logo.
①
②
③
Strap bearing
the logo
Inner side view (big toe side)
Wrap the strap bearing the logo around your ankle (①), pass it
through the loop (②), fold it back, and fasten it (③).
* Do not overtighten the straps as doing so may cut off blood
circulation to the foot or lead to skin and/or circulatory
problems.
7. Make sure that the product is not loose or out of place. If you feel any discomfort, repeat the steps from the beginning to
reattach the product.
<Back view>
The product correctly fastened (right foot)
<Inner side view><Front view>
* In the illustration, the logo is facing
frontward. The logo does not always
come into the center. Its position may
differ according to the individual user.
* Adjust the strap bearing the logo as
necessary to ensure a snug t.
Disclaimer:
* The product specications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specied by the local government.
* We take all possible measures to ensure product quality, however, if you nd any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
“ZAMST” and “ZAMST logo” are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.