ZAMST Shoulder Wrap - How to Apply; Step-by-Step Application Guide

1. Unfasten all the hook-and-loop fasteners of the product.
Conrm the top/bottom and inside/outside of the
product.
<Outside of the product>
Hook-and-loop
fastener C
Logo mark
Chest strap
<Inside of the product>
Hook-and-loop
fastener B
Hook-and-loop
fastener A
Tag
Place the side with
the size tag on the
back of the product
face up when
attaching the product
to your shoulder.
Place the back side
of the chest strap
with the blue fabric
on your body.
2. Attach the chest strap to hook-and-loop fastener A (with
a size tag) on the product.
Tag
* When attaching the
product to your left
shoulder, attach
the chest strap
to hook-and-loop
fastener B.
3. Pull the product up until the acromion (a large bony
projection) of your shoulder is positioned under the hole
of the product.
4. Pull the chest strap from the back to the front through
under your armpit, and fasten hook-and-loop fastener B
over your chest to apply appropriate compression.
Hook-and-loop
fastener B
Adjust the position of the chest strap until its center is under your armpit.
* When attaching the product to your left shoulder, fasten hook-and-
loop fastener A over your chest.
5. Fasten hook-and-loop fastener C so that the product ts
the upper arm.
Hook-and-loop
fastener C
6. Pull the product up and down to eliminate slack.
7. Make sure that the product is not loose or out of place.
If you feel any discomfort, repeat the steps from the
beginning to reattach the product.
The product correctly fastened (right shoulder)
<Front view> <Side view> <Back view>
Disclaimer:
* The product specications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specied by the local government.
* We take all possible measures to ensure product quality, however, if you nd any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
“ZAMST” and “ZAMST logo” are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
How to apply
• Before attaching this product, carefully read the "Precautions for use - Be sure to read this" section. Then follow the steps provided to ensure the
product is correctly attached.
• The steps below use the right shoulder for reference. Follow the same steps for the left shoulder.