Zanflare F1 - Power Tips; Maintenance; Warranty

Power ps
The indicator turned red: in charging
The indicator turned green: finished charging
The LED blink: remind you of changing the baery or recharging
When the voltage was under 2.8V, the LED would blink once per minute.
When the voltage was under 2.6V, the LED would blink 3 mes and then turn off.
Plz note: Twist the protecve ring around the USB and indicator, in order to prevent water or dust.
Maintenance
Do not disassemble the sealed head. Doing so can cause damage to the flashlight and will void
the warranty.
Use high-quality baeries or you run the risk of the flashlight being damaged by electrolyte
leakage or baery breakage.
If the flashlight will not be used for a long me, remove the baeries to avoid damage caused
from baery leakage.
Every 6 months, threads should be wiped with a clean cloth followed by a thin coang of
silicon-based lubricant.
Garane
3 Days DOA warranty: If the product you purchased becomes defecve within 3 days of receipt,
we will replace the item free of charge.
30 Days free return: Any item can be returned to get refund within 30 days of receipt in new
condion if you don't like it.
3 years free repair/replacement: Any lighng product sold by zanflare direct at Amazon Stores
which is found to be defecve under normal use and service within 3 years and more than 30
days counng from the date of purchasing with proof of purchase can be replaced with new
ones freely.
Lifeme limited warranty: For items purchased aer 3 years, we will sll provide warranty service,
but the cost of labor costs and maintenance with the exclusion of accessories or replacement
parts will be paid by the customers.
For the latest informaon on zanflare® products and services, please go to: www.zanflare.com
Hold the mode switch again for 2s to exit SOS or Strobe mode.
F1 automacally memorizes the last brightness level used aer turning on.
Plz note: In order to prevent overheang, F1 automacally access a lower brightness mode.