12
8. Spin speed selector dial, NO
SPIN or RINSE HOLD option
Model FA 1026 Model FA 826
This dial allows the reduction of the final and the
intermediate spin speed or to select NO SPIN
or RINSE HOLD (no-wrinkle)
options.
The speeds on the dial refer to cotton programmes.
Model FA 1026
Position 1000 r.p.m. corresponds to 900 r.p.m. for
synthetics and 700 for wool and delicates.
Model FA 826
Position 800 r.p.m. corresponds to 700 r.p.m. for
delicates.
• NO SPIN: by selecting this option all the
spinning phases are turned off. To be used for
extremely delicate items.
• RINSE HOLD (no-wrinkle): by selecting this
option the water of the last rinse is not drained.
When the programme has finished the light END
goes on. Before opening the door the water must be
drained.
To drain the water follow these three steps:
A) Turn the programme selector dial to “
O”.
B) Select programmes “Q” (DRAIN) or “R” (SPIN).
• If programme “R” (SPIN) has been selected:
Use the spin speed selector dial to choose the
required speed. If the dial is kept in the same
position as at the beginning, in other words
RINSE HOLD (no-wrinkle) position, the machine
will spin at 400 r.p.m.
C) Press START/PAUSE button.
9. Programme selector dial
The selector dial can be turned either clockwise or
counter-clockwise.
Use this selector dial to select the required
programme.
At the end of each programme the selector dial
must be turned to position “O”, to switch off the
machine.
ATTENTION!
If the programme selector dial is turned to another
position (programme) when the machine is working,
the lights of the programme progress display start to
flash. The machine will not perform the new selected
programme, but it will continue running on the same
cycle.
To Next Page
